1 cell lipo and 13.5 brushless
Motor NO Timing or Boost ALLOWED

Any ROAR approved 1 cell lipo found here: http://www.roarracing.com/approvals/lipobattery.php

Any ROAR approved 13.5 found here: http://www.roarracing.com/approvals/brushlessmotors.php

Race Length = 6 minute heats and mains

Rear Wheel Drive Only

Ride Height - 3mm Minimum

Sensor based motors only
The maximum retail price of a brushless motor shall be $129.00
Rotor Size - 12.2 mm to 12.5 mm. No Tolerances
Magnet Length - 25.0 mm +/- 1.00 mm
The inductance for each slot of the stator shall be 102.00 Micro Henries minimum and 108.00 Micro Henries maximum, measured with the rotor removed from the motor.
No hybrid (mixing of parts from approved brushless motors) allowed.

Sensor wires are to wired as follows
Pin #1- Black wire-ground potential
Pin #2- Orange wire-phase C
Pin #3- White wire-phase B
Pin #4- Green wire-phase A
Pin #5- Blue wire-temp control, 10 k Thermistor referenced to ground potential
Pin #6- Red wire-+ 5.0 volts =/- 10%

Bodies: Any COT or standard pan car body allowed (no wedge or Lola bodies)

4 cell nimh 17.5 = minimum of 40 ounces without house transponder
1 cell lipo 13.5 = minimum of 36 ounces without house transpond

ALSO, A $35.00 "Tear down" fee, can be used, when a person is accused of possibly cheating, if they are found guilty you get your money back, and they are disqualified, if found not guilty you lose your $35.00..If anyone is caught using an illegal motor, OVRCCC reserves the right to confiscate the motor. The motor will not be returned to the Owner