19 Turn Touring Car

Batteries
6 cell NIMH maximum battery pack, any pack that is readily available. Example: the new 4500 and 4600 batteries will be legal once available.

Lipo is legal but must be a hard cased 7.4 volt, 2s , ROAR approved, Lipo (found here: http://www.roarracing.com/approvals/lipobattery.php)
When charging at the track you will need to charge in an Ammo box or lipo bag. You must run a Lipo smart stop system. This can be built into the ESC or as a separate unit.

Suspension - 4wd independent
Race length - stock - 5 minutes
Bodies - Any body 2 or 4 door, NO! Gtp bodies (IE Lola, speed, 12 gtp, toyota gtp, or late model wedge body)
Wings - one rear wing allowed, single plane and must be fastened to the rear deck
Wheels & Tires - Any 1/10 scale TOURING car Rubber tire
Transmission - 1 speed only (no 2 spds)

Motors
19 Turn 24 degree LOCKED timing
Factory tagged or printing on arm stating 19 turn arm.
Bronze bushing or bearings!!
2 or 4 magnets allowed
Motor Price not to exceed $60

Or

Any Roar approved 10.5 brushless motor found here:

http://www.roarracing.com/approvals/brushlessmotors.php

Sensor based motors only
The maximum retail price of a brushless motor shall be $129.00
Magnet minimum length 23.00mm, maximum 27.00mm
Magnet minimum diameter 12.00mm, maximum 15.50mm.
No hybrid (mixing of parts from approved brushless motors) allowed.

Sensor wires are to be wired as follows and all must be connected
Pin #1- Black wire-ground potential
Pin #2- Orange wire-phase C
Pin #3- White wire-phase B
Pin #4- Green wire-phase A
Pin #5- Blue wire-temp control, 10 k Thermistor referenced to ground potential
Pin #6- Red wire-+ 5.0 volts =/- 10%

The 19 turn class will be 3 makes a class to try and build the class. All other are 4 makes a class.

Weight:
    50oz with a personal
    50oz without a track transponder