10th Scale Late Model

The only bodies legal for the Late Model class are those that have been approved and are listed below.  Molded portion of body can be no longer than 22”.  Late Model bodies may have openings for cylinder head, fuel tank access, glow plug, engine tuning, and exhaust outlets only. An under body support may be added to brace each rear quarter panel, but must hold it in stock position, can not be flared out. No additional wings, flaps, spoilers, wickers, vents or doohickeys will be allowed. Body may not be altered in any way from it’s stock configuration ie: shortened, lengthened, narrowed, flared fenders etc. Front and rear windows may be removed at trim lines but a flat lexan or similar material deck must be added in cockpit area. Bodies with add on roofs may leave front and rear windows in or out but roofs must be mounted in stock position.

Rear Spoiler: maximum chord is 2.750" from body deck including any wickerbills.  

Rear Spoiler Cap: 

bulletCustom Works #9001 Open Comp Camaro  (not legal after 12/31/10)
bulletCustom Works #9005 Pro-Mod Lumina        (not legal after 12/31/10)
bulletCustom Works #9006 Pro-Mod Thunderbird  (not legal after 12/31/10)
bulletCustom Works #9012 Eldora Late Model
bulletCustom Works #9014 Paducah Late Model
bulletCustom Works #9015 Springfield Late Model
bulletCustom Works #9070 Keystone Late Model
bulletMcAllister #207 Tulsa Late Model
bulletMcAllister #250 Vegas Late Model
bulletMcAllister #252 Winchester Late Model
bulletMcAllsiter #237 Bakersfield Late Model
bulletBMS Racing #P103 Shadow
bulletFactory Works #7353 Rocket Late Model
bulletFactory Works #7357 Concord Late Model
bulletC&M Bodies #2010 Volunteer Late Model
bulletC&M Bodies #2010-003 Nightmare Late Model
bulletStalker Bodies #009 Sniper 9 Late Model
bulletStalker Bodies #010 Sniper Late Model

Motors
Any Roar 13.5 sensored or 3500 Sensorless approved brushless motor found here:
http://www.roarracing.com/approvals/brushlessmotors.php

Batteries
Batteries - All classes are limited to Sub-C 4 or 6 cell maximum 7.2 volt battery pack, any pack that is readily available. Example: the new 4500 and 4600 batteries will be legal once available.

Lipo is legal but must be a hard cased 7.4 volt, 2s , ROAR approved Lipo 
(found here: http://www.roarracing.com/approvals/lipobattery.php)

When charging at the track you will need to charge in an Ammo box or lipo bag. You must run a Lipo smart stop system. This can be built into the ESC or as a separate unit.


2 Wheel Drive ONLY

3 Gear Box Transmission

Minimum mounting bead - 2.175”
Maximum mounting bead - 2.25"
Maximum overall - 2.46”
Maximum wheel width - 2”

Tire width - Minimum - 2" Rubber or Foam
Maximum - 2.125”
Minimum tire diameter - 3.6”

Race length: 6 minutes

Minimum weight – 56 ounces